Need to make one of our popular Tambor Rolls shorter in height? No problem.

What you will need for the perfect finished cut:

1. A miter saw with a fine tooth blade (72 teeth or above)
2. Some shrink wrap or postal tape.
3. A marking pen and measuring tape of course.

The Tambor comes in a tight roll so you will want to maintain this during your cut. Tape the ends together.
(See picture 1)

Next determine the length needed and place a small mark on the Tambor Roll. You will then wrap more shrink wrap or postal tape around the mark where your cut will be. The tape/shrink wrap will aid in the extra clean cut so you do a splintering effect. Safety first, so if you have an extra hand this will go more smoothly with two people. With both ends supported by you and a friend, simply bring the blade down directly with a steady and consistent pressure.
(See picture 2)

The results, a factory cut ready to be installed as wainscot, on a tiki bar, or for an office or home project.
(See picture 3)

Cutting regular bamboo poles (lumber)? Repeat the same steps as listed above.

When cutting our bamboo fence panels a different cutting process will be required. See our article on “Building an Indoor Privacy Screen” located on our home page.

You are always welcome to call if you have any questions.

www.bambooandtikis.com
866-222-1422